Marzocchi BOMBER 2005, Руководство пользователя

Страница: 27 / 59

Maintenance
M
Z
024
English
4
115
4.3 Cleaning the fork legs
The manufacturer lubricates the fork dust seal
with some grease, which makes the stanchion
tubes slide easier, especially when the fork has
not been used for a long time.
When using the fork, such grease can melt and
stick to the stanchions, looking like an oil leak,
although it is not.
After every use carefully clean the fork’s outside
surfaces, with a special attention to stanchion
tubes and dust seals.
WARNING !
Mud and dust may cause serious damages to
the suspension system if not immediately
removed.
4.4 Monster T air bleeding
Picture 12
This operation must be carried out with the fork
assembled on the bicycle and with the fork’s legs
fully extended (front wheel off the ground)
The pressure generated by the air that can get
into the fork legs while the bike is being used and
which, due to the special shape of the oil seals
remains trapped inside, can cause the fork to
malfunction.
• In case of malfunction or loss of legs’
smoothness please carry out following
operation on both legs:
• By means of a 2 mm Allen key, unscrew the
air bleed screw ( A ) located on the cap, in order
to drain the pressure generated inside the
fork’s leg.
• Check the oil seal ( B ) condition; replace if
needed.
• Tighten the air bleed screw ( A ) to the
recommended torque ( 2±0,5 Nm ), being
careful not to damage the oil seal ( B ).
Picture 12 - Monster T air bleeding
2±0,5 Nm
2 mm
M
Z
02401
2