STARTING AND STOPPING PROCEDURE
Before Starting The Engine:
Fill the fuel tank as instructed in the BEFORE OPERATION section
and prime the water pump as instructed in the operating The Water Pump section of this manual.
To Start Engine:
Step #1) Pump the primer-bulb at the bottom of
the carburetor until fuel can be seen
flowing thorough the fuel-return line to
the fuel tank. (Fl9wing fuel should be
clear, not foamy or full of bubbles.)
Step #2) Turn the choke lever to the close position.
Step #3) With the stop switch "ON", and the
throttle lever positioned at IDLE, pull the
starter cord. After the engine is started,
turn the choke lever to the Open position.
PRIMER BULB
FUEL-RETURN LINE
PULL TO START
CHOKE LEV!:R
IDLE POSITION
STOP
SWITCH
THROTTLE LEVER
For starting an er,igine that is already warmed-up (hot restart), or if the ambient temperature
exceeds 70
°
F (20
°
C), turn the choke lever to the Open position, and perform Steps #1) and #3).
(If a
MARUYAMA
engine fails to start after following the above procedures, contact an authorized
MARUYAMA
dealer.)
To Stop The Engine:
1. Move throttle lever to the idle position.
2. Move the stop switch to the "OFF" position.
-9-
