Connecting Stop Switch Wires
Stop Switch Wires
Plastic Tube
I
Stop Switch Wires
Throttle Cable
Air Cleaner Cover
Knob
1.
Install the plastic tube (packed with the drive shaft
assembly) around the throttle cable and stop ·
switch wires.
2.
Loosen the knob and remove the air cleaner cover
to access the stop switch wires.
3. Plug the stop switch wires into the matching con
nectors from the engine. Note that wire polarity is
not important.
Connecting Throttle Cable
Cable Adjuster Sleeve
Throttle Cable Housi
�
g
i
Throttle Cable
Slotted Fitting
Recessed
Cable
Lug
Carburetor Throttle Cam
Throttle Stop/Idle Speed
Cable Adjuster Sleeve
"II :;:::.
Adjuster Screw Bracket
Idle Speed
Adjuster Screw
Slotted Fitting
I.
With the air cleaner cover removed, insert the
throttle cable through the cable adjuster sleeve on
the carburetor bracket. Make sure the end of the
cable housing is seated positively in the sleeve.
2.
Position the slotted fitting on the carburetor so the
recessed hole for the cable lug is away from the
cable adjuster sleeve.
3.
Rotate the carburetor throttle cam clockwise and
slip the throttle cable through the slot in the slot
ted fitting, making sure the cable lug drops into
the recessed hole.
4. Operate the throttle trigger a few times to make
sure that it works correctly.
5.
Adjust the cable adjuster sleeve so the stop on the
carburetor throttle cam just contacts the throttle
stop when the throttle trigger is fully depressed.
-9-
