- 4 -
Symbol explanation
Assembly
Assembling Gearcase and Drive Shaft Assembly
Insert the driveshaft tube assembly into the gearcase assembly
while rotating the clutch drum to engage the splines.
Align the locating holes and install the locating screw through
the side of the gearcase. Then tighten the clamping screws.
Assembling Engine and Drive Shaft Assembly
Attach the clutch drum housing to the engine using the four
screws supplied with the unit.
Loop Handle Installation
1. Place the loop handle and the bottom clamp on the shaft
approximately 28cm(11 inches) from the end of the stop switch/
throttle trigger assembly.
2. Install the four screws and nuts. Tighten the screws evenly.
3. Reposition the loop handle up or down the driveshaft to the
most comfortable position, and tighten the screw and nuts.
Engine
Screw (4)
Clutch Drum
Housing
Splines
Locating Hole
Clamping Screw
Locating
Screw
Gearcase
Shaft Assembly
Loop Handle
Screw (4)
Bottom Clamp
Nut (4)
Indicates Warning, Danger, Caution.
・
Wear head protection, where there is a risk of falling objects.
・
Wear eye protection, while operating the Hedge Trimmer.
・
Wear ear protection, while operating the Hedge Trimmer.
Do not put hands and feet near or under moving blades.
Read and understand this Owner’s/Operator’s Manual.
