Maruyama AHT2600D-RS Скачать руководство пользователя страница 4

- 3 - 

3m Minimum

 

 

3. Shut off the engine and be certain the blades has completely stopped moving before performing 

    maintenance on or working on the machine. 

      4. Make sure the blades does not move at engine idle speed. Refer to Idle Speed Adjustment page 9. 

      5. Inspect the blades and replace any parts that are cracked, chipped or damaged before using the 

  Hedge Trimmer. 

      6. Never use a blades or replacement parts that are not approved by MARUYAMA. 

      7. Maintain the Hedge Trimmer according to the recommended maintenance intervals and   

     procedures in the Maintenance section beginning on page 11. 

      8. If running problems or excessive vibration occur, stop immediately and inspect the unit for the   

     cause. If the cause cannot be determined or is beyond your ability to correct, return the Hedge   

          Trimmer to your servicing MARUYAMA dealer for repair. 

      9. When transporting the Hedge Trimmer always fit the blade cover. 

Fuel safety

 

1. Gasoline is highly flammable and must be handled and stored carefully.   

    Use a container approved for fuel for storing gasoline and/or fuel/oil mixture. 

      2. Mix and pour fuel outdoors and where there are no sparks or flames. 

      3. Do not smoke near fuel or Hedge Trimmer, or while using the Hedge Trimmer. 

      4. Do not overfill the fuel tank. Stop filling 10mm from the top of the tank. 

      5. Wipe up any spilled fuel before starting the engine. 

6. Move the Hedge Trimmer at least 3m away from the fueling location 

    before starting the engine. 

7. Do not remove the Hedge Trimmer fuel tank cap immediately after   

    stopping the engine. 

      8. Allow the engine to cool before refueling. 

      9. Drain the tank and run the engine dry before storing the unit. 

    10. Store fuel and Hedge Trimmer away from open flame, sparks and 

     excessive heat. Make sure fuel vapors cannot reach sparks   

          or open flames from water heaters, furnaces, electric motors, etc. 

Hedge Trimmer Operating safety

 

THIS HEDGE TRIMMER CAN CAUSE SERIOUS INJURIES. Read the instructions carefully.   

      1.Be familiar with all controls and the proper use of the Hedge Trimmer. 

      2. Never allow children to operate the Hedge Trimmer. It is not a toy. Never allow adults to operate the   

     Hedge Trimmer without first reading this Operator’s Manual. 

      3. Avoid using the Hedge Trimmer near rocks, gravel, stones and similar material that would cause   

     harmful missiles. 

      4. Keep children, bystanders and animals outside a working area of the Hedge Trimmer. 

      5. If someone are approached while operating the Hedge Trimmer , stop the engine and the blades 

          moving. 

      6. Use the Hedge Trimmer only in daylight or good artificial light. 

      7. Never operate the Hedge Trimmer without proper guards in place. 

      8. Do not put hands or feet near or under any moving parts. Keep clear at all times. Keep all parts of   

          your body away from the moving the blades and hot surfaces such as the muffler. 

      9. Keep a firm footing and balance. Do not overreach. 

    10. Use the right tool for the job. Do not use the Hedge Trimmer for any job that is not recommended by   

     MARUYAMA. 

 

 

Содержание AHT2600D-RS

















Отзывы: