MARUTI SUZUKI 800, Руководство пользователя

Страница: 78 / 120

78
MARUTI 800 DOMESTIC
844-74E
INSPECTION AND MAINTENANCE
ENGINE COOLANT
Adding Coolant
If the Coolant level is below the “LOW”
mark, more coolant should be added.
Remove the reservoir tank cap and add
coolant until the reservoir tank level reaches
the “FULL” mark. Never fill the reservoir
tank above the “FULL” mark.
• When adding or replacing coolant,
use a high quality ethylene glycol
antifreeze and anticorrosion diluted
with distilled water. If the lowest
ambient temperature in your area is
expected to be -15
0 C (5 0 F) or above,
make the antifreeze concentration of
the mixture you use at least 30%
but no more than 50%. If -16
0 C (3 0 F)
or below, make the concentration at
least 50%. If the 50% concentration
does not provide adequate
protection agains freezing, follow
the instructions on the antifreeze
container to obtain the desired
freezing point.
Coolant Level Check
Check the coolant level at the reservoir
tank, not at the radiator. With the engine
cool, the coolant level should be between
the “FULL” and “LOW” marks.
CAUTION
It is dangerous to remove the radiator
cap when the water temperature is
high, because scalding fluid and
steam may be blown out under
pressure. Wait until the coolant
temperature has lowered before
removing the cap.
Coolant Replacement
Since special procedures, materials and
tools are required, it is recommended that
you trust this job to your authorized
MARUTI SUZUKI dealer.
w w w w w
WARNING
9-11
844-09-012 844-09-013