© Martin Engineering GmbH
34
M3625UK-10/15
Maintenance
6
Maintenance
6.1
Safety instructions
6.2
Maintenance procedure
1. Check that all securing parts are tightened. Tighten any loose
connections as required.
2. Carry out maintenance measures according to the mainte-
nance table
3. Switch on the conveyor system and perform a test run
(see Chapter 5.3).
NOTE
Maintenance inspections must be carried out at least at the inter-
vals specified in the maintenance table. Depending on operational
conditions, shorter maintenance intervals may be necessary.
NOTE
Read this chapter thoroughly prior to commencing any work.
WARNING! DANGER OF INJURY!
Body parts and/or clothing may get caught and pulled in by rotat-
ing parts or by the moving conveyor belt.
Before maintenance work is carried out, ensure that all power
sources to the conveyor belt system and its accessories are
switched off and secured against inadvertent switching-on.
Use warning signs!
CAUTION! FLYING PARTS!
Tools that have been left behind inadvertently may fall from a mov-
ing conveyor belt and may cause minor injuries and damage to
property.
After completing maintenance work, first remove tools from the
working area and from the conveyor belt. Only then switch on the
system.
