Martin MAC 600, Руководство пользователя

Страница: 4 / 28

4 0$&(
•
Verify that all external covers and rigging hardware are securely fastened and use an approved means of secondary
attachment such as a safety cable.
•
Block access below the work area whenever installing or removing the fixture.
•
Do not lift the fixture by its head.
s e c t i o n 2
SETUP
This section describes the simple steps required to prepare the MAC 600/E for operation.
Unpacking
The MAC 600/Epackage includes:
•
2 Fast-Lock Omega clamp brackets
•
5-meter XLR-XLR control cable
•
Light snoot
•
User manual
The packing material is carefully designed to protect the fixture during shipment - always use it or a custom MAC 500/600
flight case to transport the fixture.
Installing or changing the lamp
W A R N I N G !
Disconnect the fixture from AC power before proceeding. Always wear safety
goggles to protect your eyes and allow a hot lamp to cool for at least 15 minutes
before removing it from the fixture.
The MAC 600/E works with the Philips MSR-575/2 and MSD-575, and the Osram HSR-575/2.
,QVWDOOLQJDQ\RWKHUODPSPD\ GDPDJHWKHIL[WXUHThe lamp holder is pre-adjusted at the factory; precise
alignment may be necessary due to slight variations between lamps. The procedure is described on page 17.
1. The MAC 600/E must be cool and isolated from AC power. Remove the 2 thumbscrews securing the lamp-
socket assembly to the rear of the head. Pull out the lamp-socket assembly.
2. If changing the lamp, remove the old lamp from the socket.
3. Holding the new lamp by its ceramic base (do not touch the glass), insert it firmly and squarely into the lamp
socket.
4. Clean the glass bulb with the cloth supplied with the lamp, particularly if your fingers touch the glass. A clean,
lint-free cloth wetted with alcohol may also be used.
5. Keep the lamp wire between the fins as you insert the lamp-socket assembly into the head. Turn the assembly
counterclockwise to align the holes with the spacer nuts. Replace the thumbscrews and tighten them by hand.
6. Before striking the lamp, reset the RLAH and RLST counters under the TIME menu to track lamp hours and
lamp strikes. See page 13.