11) Attach clutch electrical connector to machine harness. Orientation of the connectors to one an-
other is not critical. A user-supplied plastic tie may be wrapped around connectors to assure they
hold in position if desired.
12) Remove circuit board cover located directly beneath feed table exposing the circuit board. Lo-
cate program chip on board as shown in picture below. Remove this chip by prying on it with a small
flat bladed screwdriver.
13) Locate new chip included with Retro-Kit. Carefully install in folder board opposite of old chip re-
moval. Text on chip label should be oriented as shown in picture below. Assure all chip pins are in-
serted in the mounting socket while pushing chip into position. Basic static control precautions should
be taken while this operation is being performed (at the very least, ground yourself before touching
chip to eliminate static electricity).
Clutch Electric Connector---
Hook Up to Folder Harness
and Wire Tie Up
Circuit Board Cover----Remove (2)
Screws to Access Circuitboard
Carefully Remove Chip by Prying up
on Chip with a Small Screwdriver
(5)
Fender Washer and Small E-Ring
Holding Clutch Gear in Position
