5) As Feed Shaft is inserted through sideframe, place a single plastic spacer (washer) on shaft.
While holding the new Feed Wheel over retarder with the brass center bearing located towards the
OPERATOR side of folder, push feed shaft through the Feed Wheel. Once the Feed Shaft clears the
Feed Wheel, place other plastic spacer on shaft and continue to push shaft into the operator side-
frame. Installation may be easier if the tension on the paper retarder is relieved during this process
by turning the retarder adjustment fully clockwise.
6) Push both plastic spacers to their corresponding side frames. Once both plastic spacers are in
their proper locations, the 4 E-Rings removed in step #3 above may be re-installed.
7) Remove the top cover grommet-stop screw on back side frame and replace with the longer one in-
cluded with retro-kit. Older machines may have a pressed stud in this location. If this is the case, drill
out that stud and replace with screw, standoff, and nut as shown in pictures below.
New Feed Shaft Being Slid Into Folder
(4) E-Rings To Be Installed in
These Locations
(3)
Installing New Feed Shaft into
Folder---Note Orientation of Small
Journal on End of Shaft. It Goes
Towards the Side of Folder with
Removed Sidecover!!!!
