9
St Stopping
m
WARNING!
Be sure the trigger switch is released when
changing the position of the f reverse selector switch.
Always store the tool in the locked/off position.
1. To start the cordless driver, press the trigger switch
(Fig. 11).
2. Release the trigger switch to stop (Fig. 11).
LED Light
The cordless driver is equipped with an LED light below the
bit collet to provide additional lighting for operation in low light
conditions. The LED light will turn on when the trigger switch is
pressed (Fig. 12).
Cl Maintenance
m
WARNING!
To avoid accidents, always disconnect the
tool and/or charger from the power supply before cleaning.
The tool may be cleaned most effectively with compressed
air. Always wear safety goggles when cleaning tools with
compressed air.
Ventilation openings, trigger switch and loading bolts must be
kept clean and free of foreign matter. Do not attempt to clean
by inserting pointed objects through opening.
m
CAUTION!
Certain cleaning agents and solvents
damage plastic parts. Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents, ammonia and
household detergents that contain ammonia.
m
WARNING!
No user serviceable parts inside. Preventive
maintenance performed by unauthorized personnel may result
in misplacing of internal wires and components which could
cause serious hazard.
Battery C Disposal
Disposal
Should your appliance need replacement after extended
use, do not dispose of it with the household refuse, but in an
environmentally safe way.
Waste produced by electrical machine items should
not be handled like normal household rubbish. Please
recycle where recycle facilities exist. Check with your
local authority or retailer for recycling advice.
Always dispose of your battery pack according to federal,
state, and local regulations. Contact a recycling agency in your
area for recycling locations.
m
CAUTION!
Even discharged battery packs contain
some energy. Before disposing, use electrical tape to cover
the terminals to prevent the battery pack from shorting, which
could cause a fire or explosion.
m
WARNING!
To reduce the risk of injury or explosion,
never burn or incinerate a battery pack even if it is damaged,
dead, or completely discharged. When burned, toxic fumes
and materials are emitted into the surrounding atmosphere.
1. Batteries vary according to device. Consult your manual
for specific information.
2. Install only new batteries of the same type in your product
(where applicable).
3. Failure to insert batteries in the correct polarity, as
indicated in the battery compartment or manual, may
shorten the life of the batteries or cause batteries to leak.
4. Do not mix old and new batteries.
5. Do not mix Alkaline, Standard (Carbon-Zinc), or
Rechargeable (Nickel Cadmium, Nickel Metal Hydride, or
Fig. 11
Trigger switch
Fig. 12
LED light
