7
Assembly
• Before inserting the bit cylinder, make sure the f
reverse selector switch is in the center “LOCK” position to
prevent accidental starts that may result in injury.
• When removing the bit cylinder from the tool, avoid
contact with skin and use proper protection gloves when
grasping the bit. Bits may be hot after prolonged use.
NOTE: To install or remove the bit cylinder, loading bolts must
be pulled to the back and locked into place.
Bit cylinder can only be installed or removed from the right side
of the driver.
Installing Driver Bit Cylinder
1. Position the f reverse selector switch to the
center “LOCK” position (Fig. 2).
2. Press and slide the loading bolts on both sides to the back
then release the loading bolts to lock into place (Fig. 3).
3. Position the bit cylinder with bits facing forward and press
it into the bit chamber opening from the right side (Fig. 4).
Removing Driver Bit Cylinder
1. Position the f reverse selector switch to the
center “LOCK” position (Fig. 2).
2. Press and slide the loading bolts on both sides to the back
then release the loading bolts to lock into place (Fig. 3).
3. Push the bit cylinder from the left side to the right side and
remove it from the chamber (Fig. 5).
Forwar
d
Revers
e
Lock
Fig. 2 F reverse
selector switch
Center "LOCK" posiition
Fig. 3
Loading bolts
Fig. 4
Bit cylinder
Bit chamber
Fig. 5
Bit cylinder
Bit chamber
