8
Operation
L Unloading Driver Bits
1. Position the f reverse selector switch to the
center “LOCK” position (Fig. 2).
2. Press and slide the loading bolts on both sides to the
back then release the loading bolts to lock into place
(Fig. 3).
3. By rotating the bit cylinder in the chamber, select the
driving bit best suited for the job and place it to the top.
You can view the selected bit through the bit port (Fig. 6).
NOTE: For the cylinder to rotate, the loading bolts must
be slide to the back and lock into place.
4. Press and slide the loading bolts on both sides forward to
load the selected bit into the collet (Fig. 7).
NOTE: The loading bolts will not advance if the cylinder is
not properly seated in the top position.
5. Sliding the loading bolts back will draw the bit back into
the bit cylinder.
Selecting the Direction of Rotation
m
WARNING!
Be sure the trigger switch is released when
changing the position of the f reverse selector switch.
Always store the tool in the locked/off position.
NOTE: Always check the direction of the cordless driver
rotation before use.
1. To select forward rotation, press the forward selector
switch from right to left flat against the cordless driver
(Fig. 8).
2. To select reverse rotation, press the reverse selector
switch in the opposite direction (Fig. 9).
3. The center position locks the tool (Fig. 10).
Fig. 6
Bit cylinder
Bit port
Fig. 7
Loading bolts
Bit
Collet
Fig. 8
forward rotation
switch
Fig. 9
Reverse
rotation switch
Fig. 10
To lock
the tool
To lock
the tool
