OWNER’S MANUAL
MODEL HT18 AUTOTOAST™ HORIZONTAL TOASTER
144328 RV050514
8
Copyright
2013 Marshall Air Systems, Inc.
All Rights Reserved.
9. PROBLEM: Gap setting knobs jammed.
SOLUTION:
OPERATOR CHECK:
A. Turn knobs counter-clockwise. Indicator is read using top edge.
B. Turn both knobs at same time. Platen sheet could be interfering.
10. PROBLEM: Conveyors turning intermittently.
SOLUTION:
OPERATOR CHECK:
A. Make sure carriage is pushed back and latch is engaged.
B. Check for bent parts on the carriage; for example, handle, back flange.
C. Check bottom rail flange for bending. Refer to the Technical Bulletin at the end of this manual
for instructions.
D. Tighten latch mechanism. Use a screwdriver and 7/16” wrench. It is necessary to remove right
side cover to access.
E. Conveyor bearings need replacing
11. PROBLEM: “Shim” required between latch and conveyor carriage to get conveyors to turn.
SOLUTION:
A. Latch is bent. Bend latch back to straight.
12. PROBLEM: Conveyors continue to run after unit is turned off.
SOLUTION:
A. Cycle On/Off again to see if motor stops.
B. Motor must be replaced.
13. PROBLEM: Motor Noisy/Chirping
SOLUTION:
A. Remove motor brushes and inspect. If ¼” less, replace with new.
B. If longer than ¼”, replace brushes and tighten cap. Do not over tighten.
