Marquis Capri IDV34 Series, Руководство по установке

Страница: 7 / 70

Important Information
INSTALLATIONS

The following label (supplied with the gas fireplace
insert) must be attached with rivets or screws to the
inside of the firebox of the fireplace into which it is
installed:

Cutting any sheet-metal parts of the fireplace, in
which the gas fireplace insert is to be installed, is
prohibited.

If the factory-built fireplace has no gas access hole(s)
provided, an access hole of 1.5 in (37.5 mm) or less
may be drilled through the lower sides or bottom of
the firebox in a proper workmanship like manner. This access hole must be plugged with non-combustible insulation after
the gas supply line has been installed.

The fireplace flue damper can be fully blocked open or removed for installation of the gas fireplace insert.

Ensure that existing chimney cleanouts fit properly.

refractory, glass doors, screen rails, screen mesh and log grates can be removed from the fireplace before installing the
gas fireplace insert.

Smoke shelves, shields and baffles may be removed if attached by mechanical fasteners.

Trim panels or surrounds must not seal ventilation openings in the fireplace.

The fireplace and fireplace chimney must be clean and in good working order and constructed of non-combustible
materials.
MAINTENANCE

If for any reason the vent air intake system is disassembled, re-install and re-seal per the instructions provided for the
initial installation. See “Installation of Vent Pipe” section.

It is recommended to annually inspect and clean the Burner System to prevent malfunction and / or sooting. This
operation should be performed by your dealer or a qualified technician. Refer to Burner System Maintenance section.

Venting systems should be periodically examined by a qualified agency.

Periodically remove the logs from the grate assembly and vacuum any loose particles from the grate and burner areas.
See Log Placement page to remove logs. Vacuum burner parts and replace logs.
-Glass Safety- All Units
IT IS THE RESPONSIBILITY OF THE HOME OWNER
TO ENSURE THAT NO ONE TOUCHES A HOT
APPLIANCE.
If the barrier becomes damaged, the barrier shall be
replaced with the manufacturer’s barrier for this
appliance.
Any safety screen, guard, or barrier removed for
servicing the appliance, must be replaced prior to
operating the appliance.

Children and adults should be alerted to the hazards of
the high surface temperatures of this appliance and
should stay away to avoid burns or ignition of clothing.

Do not clean when the glass is hot.

Young children should be carefully supervised when
they are in the same room as the appliance. Toddlers, young children and others may be susceptible to accidental contact
burns.

A physical barrier is recommended if there are at risk individuals in the house. To restrict access to a fireplace or stove,
install an adjustable safety gate to keep toddlers, young children and other at risk individuals out of the room and away
from hot surfaces.

Do not leave the fireplace remote control where it is accessible to children.
7