M A R Q U I S S P A S • R E L A X I N G Y O U R W O R L D 8
I N S T A L L A T I O N I N S T R U C T I O N S
OVERHEATING
In the case of extended hot weather, the spa water temperature may reach and maintain
104° F to 106° F. This is due to the ambient temperature and the full insulation in the
spa cabinet. The simplest solution to this heat buildup is, lifting the spa cover a few
inches for several hours to allow the heat to escape. You may also have the option of
shortening the pump-run time. See Control panel section for available options.
FILTER CARTRIDGE
Your portable spa is equipped with the Constant Clean
Filtration system. All 2000 and
beyond Marquis Spas use #5040, 50 sq. ft. T-Handle Filter cartridge.
Oasis, Spirit, Mirage, Spirit LX, Mirage LX, 500, 600 and 700:
Features Vortex
Filter that includes Hi-Flo Vortex skimmer and filament filter cartridge.
500 LX, 600 LX, 700 LX, Reward, Destiny, Euphoria, Voyage, Marquis and
Journey US:
Features two Vortex Filters which include Hi-Flo Vortex skimmers and
filament filter cartridges.
NOTE
:
It is very important that the components of these filtration systems be installed
properly in the proper part of the spa (see jetting diagram and REMOVING THE FILTER
for complete instructions).
J
SUCTION FITTINGS
There are suction fittings in the footwell of your spa.
These are openings through which the jet-pumps draw
water. They have been equipped with safety covers.
Suction through the fittings can be strong. The safety
covers must remain in place and undamaged. A fitting
with a damaged cover can be dangerous, especially to
small children or people with long hair. Should any part
of the body become drawn to a fitting, turn the jet-
pump off immediately. Long hair should be restrained
in a bathing cap, never allow it to float freely in the spa.
Replace any missing or damaged suction covering.
OZONATOR INSTALLATION ON LEISURE AND SPORT SERIES
If your Leisure or Sport Series spa was not originally equipped with an ozone generator
and you would like to install one, refer to the following instructions and those supplied
with the ozonator. NOTE: The only ozonator U.L. listed for your spa is the Marquis
Spa Ozone Generator, available at your Marquis retailer, part OZU 120.
1. Turn off the power to the spa.
2. Open the equipment area door.
3. Plug the ozonator into the ozone receptacle on the spa control box.
4. Cut a 5" piece of the supplied 1/4" tubing and using silicone sealant, push one end
onto the 1/4" barbed fitting on the ozonator.
5. Into the other end of this tube, insert the supplied check valve, being sure the
direction of flow is away from the ozonator, not toward it.
6. Cut a long piece of tubing and make a loop approximately 8-10" in diameter, then
push it onto the exposed end of the check valve.
(CONTINUED)
