THERAPY PUMP(S)
Allow the spa to circulate on high-speed (see instructions for spa side controls) for 4-5
minutes to discharge air from the plumbing system. Do not expect hot water immedi-
ately from the jets; the heater will take several hours to heat the water.
Pr Diagnostic Message
NOTE:
Coastal and Ultimate Series spas have a pump priming feature which begins
at start-up. When the spa is energized, the LCD panel will display a Pr message. This
mode will last approximately four to five minutes if not exited manually. To exit
manually, press the TEMP SET pad. At this time
the spa should have water flowing from the jets.
If the pump has not primed and water is not
flowing from the jets after two minutes
,
TURN
OFF POWER TO THE SPA.
Vent air from
the pumps by slightly opening the pump unions
(see TROUBLESHOOTING section, Water
Flow). After turning the power on again, the
spa will initiate a new priming mode. Repeat
steps above.
After you have manually exited the priming mode (or you allowed the spa to automati-
cally exit) the LCD display will momentarily display 100° F and then the display will
switch to - -° F. The system requires approximately one minute of water flow to deter-
mine the water temperature. After one minute of water flow, the temperature will be
displayed as actual water temperature F. Press the TEMP SET pad to adjust the desired set
temperature for the spa.
NOTE:
Your spa has been filled and test-run at the factory. The first time your spa is
filled with water, some discoloration from residual test
water may appear. This will disappear when the spa is
completely filled and the filtration system is functioning.
Test the water for the proper chemical balance and adjust
as necessary.
Marquis Spa Care
Products
are recom-
mended.
PROPER CHEMICAL BALANCE IS
IMPORTANT.
SAFETY ENERGY COVER
When the spa is not in use, the safety energy cover
should be kept on the spa to retain the waters heatand
to keep out dirt, leaves, etc. Your heater will maintain a
constant water temperature between spa uses.
For your safety and convenience, the cover is
equipped with safety locks. Marquis suggests that you
use them to help keep out unintended users and
prevent covers from being blown off in windy condi-
tions. For high wind areas,
Secure Straps
are available.
Duralift cover lifts are also available to assist you in
cover removal. See your Marquis Dealer.
M A R Q U I S S P A S • R E L A X I N G Y O U R W O R L D 1 2
J
O P E R A T I N G Y O U R S P A
J
