Marquant 014331, Руководство по эксплуатации

Страница: 52 / 55

EN
52
• The display mode closes after 20
seconds if no buttons are pressed, or
when the "A" button is pressed.
• When a warning for temperature or
humidity from the remote sensor for
temperature/humidity is shown, tap the
"G" button to switch to display data
from other channels. There is a total of 4
channels: OUTDOOR, CH1, CH2, CH3.
For each item, press the "B" button to activate
or deactivate a warning.
NOTE:
As standard the weather warnings are
deactivated and OFF is shown in the display.
ON is shown when a weather warning is
activated.
• Press the "H" button for 3 seconds to
activate settings mode for weather
warnings.
• Tap the "D" or "E" button to change the
value. Press the "D" or "E" button to
quickly change the value.
• Tap the "H" button to confirm and go to
the next item.
NOTE:
• The settings mode closes after 20
seconds if no buttons are pressed, or
when the "A" button is pressed.
• Make the required settings for the
values from the remote sensor for
temperature/humidity and press the
button to switch channel. There is a total
of 4 channels: OUTDOOR, CH1, CH2, CH3.
DISPLAY AND SETTINGS SEQUENCE
1. High temperature from remote sensor for
temperature/humidity
2. Low temperature from remote sensor for
temperature/humidity
3. High humidity from remote sensor for
temperature/humidity
not connected to the channel, it will
show --.
• To add or replace a sensor, switch to
channel display mode and press the "G"
button for at least 3 seconds. The weather
station searches for sensor signals for 3
minutes and the new sensor channel is
added to the station.
NOTE:
• When a sensor is added or replaced, or
when changing the battery in an
existing sensor, the sensor must be
started before carrying out the above
step.
• When the icon for discharged battery is
shown (figure 1, pos. 15) on the display
the battery in the sensor with the actual
channel must be replaced immediately.
Follow the above instructions to connect
the wireless sensor to the weather
station again.
• Press the button for 3 seconds when the
clock display is shown. The values shown
from the remote sensor for temperature/
humidity change every 5 seconds between
the different channels
(OUTDOOR|CH1|CH2|CH3) and the display
switches between showing temperature
and humidity.
IMPORTANT:
In switching mode only the values for
temperature and humidity are converted,
while the values for wind speed, wind
direction and precipitation etc. are not
converted. These values are still derived from
the multifunctional wireless remote sensor.
SETTING AND DISPLAY OF WEATHER
WARNINGS
Tap the "H" button to show weather warnings
mode. Press the button repeatedly to conform
and go to the next item.
NOTE: