Marmony MTC-40, Руководство по эксплуатации

Страница: 14 / 24

14
SETTINGS
CONSTANTS
In the display at the top left you can see OFF and at the bottom the
“1” value is flashing. Press the “SET / OFF button” to confirm. This
value is not relevant for marmony infrared heaters and must not be
changed. Confirm value by pressing the “SET / OK button” to confirm.
Recommended setting for marmony infrared heaters: 1
Set open window function:
The display says open and the “1” is flashing at the top left. This pre-
set value must not be changed. Confirm value by pressing the “SET /
OK” button. The programming of the CONSTANTS is now complete,
the thermostat saves the values which are entered independently and
returns to the previous “ON / OFF” mode.
This function is to be activated for marmony infrared heaters
in accordance with the Ecodesign Directive. (Active in factory
settings)
Note: The open window recognition is a function defined by the energy saving
regulations to increase the energy efficiency. If the identified room temperature
sinks within approx. 5 minutes by approx. 2 °C (e.g. through an open window in
winter), the thermostat recognises this and switches the heater off. The display
now reads “OPEN”. After closing the window, the room temperature increases
slightly again, which the thermostat notices and switches to heating mode again. If
you forget to close the window again, the heating mode is activated again after 30
minutes to prevent frost damage in your rooms.
Recommended setting for marmony infrared heaters: “1”
The installation settings are now complete!