Page 4 of 7
1. Strip 8–10 mm (½ in) of insulation from the
end of each cable.
For the
POWER
connection, attach the
suppression ferrite (supplied) around both
the positive and negative power cables,
between the cable
clamp and SmartPilot computer. When you
attach the ferrite, you must loop both power
cables so that the ferrite encloses two passes
of each cable. Secure the ferrite with the
small tie-wrap.
2. Use a small screwdriver to loosen the screw
on the terminal block.
3. Insert the stripped cable into the terminal and
tighten the screw.
45DS Electrical Stage
Autopilot System Installation
All SmartPilot
computer terminals
will accept stranded
cable up to 2.5 mm
(14 AWG).
Connect the
following elements
as shown in the
diagram:
1. Compass
2. Rudder Sensor
3. SmartPilot
Controller via
SeaTalk
