17
SAVE
4
4
SAVE
4
4
Examine the 3 different feature charts enclosed and decide which feature will get changed. Circling the feature to
be changed will make the programming process much easier to perform.
Before 15 seconds has passed, push and release the
valet switch 2 times holding the button down on the
2nd press. Wait until 1 short and 1 long chirp or beep
is heard. Release the button. You are now in “Alarm
Feature Programming (Group 1)” mode
ON
O F F
3X
1X + 1X (Hold)
With the ignition switch in the OFF position, Turn the
ignition switch On - Off - On - Off - On
Before 15 seconds has passed, push and release the
valet switch 3 times holding the button down on the
3rd press. Wait until a long chirp or beep is heard.
Release the button. You are now in transmitter
programming mode.
ON
O F F
3X
2X + 1X (Hold)
Press the “Lock” button on the first
transmitter until you hear a confirmation
chirp/beep. The transmitter is now
coded into the system.
Repeat for each additional
transmitter.
When finished, either turn off the
ignition key or wait for 15 seconds
to get out of transmitter programming
mode. You will hear 3 long chirps/
beeps to indicate you are out of the
transmitter programming mode.
O F F
Programming the Remote Transmitter
(Includes the Standard Type and LCD Transmitter Type)
Note:
This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is
exceeded, the security system will start deleting transmitters from memory in chronological order.
With the ignition switch in the OFF position, Turn the
ignition switch On - Off - On - Off - On - Off
Step 1
Programming the Transmitter
Step 1
Step 3
Step 4
Step 5
Exit Programming
Alarm Feature Programming (Group 1)
Step 1
Step 2
