6
OPERATION
WARNING:
►
Hot oil and hot surfaces can cause severe burns. Use caution when operating the fryer.
►
Do not attempt to move the fryer filled with hot oil or shortening.
►
Do not go near the area directly above the flue when fryer is in operation. Severe burns may
be caused.
►
Drain hot oil in metal contains, do not use plastic buckets or glass containers.
Before lighting, check all joints in the gas supply line for leaks.
DO NOT USE AN OPEN FLAME TO CHECK FOR LEAKS!
Putting an open flame beside a new gas connection is extremely dangerous.
DO NOT USE APPLIANCE DURING PROLONGED POWER FAILURE AS THE VENT HOOD MAY NOT BE IN
OPERATION RESULTING IN INADEQUATE VENTING!
CAUTION: When lighting pilots and checking for leaks, do not stand with your face close to the
combustion chamber.
Check all gas connections for leaks with a soapy water solution before lighting any pilots.
Preparation Before use:
New units have a coating of oil on the interior of the vessel. Remove this coating with hot soapy water,
washing soda, or any other grease dissolving liquid. Rinse thoroughly and drain until all residues are
removed. Wipe dry. Clean the baskets, crumb screen.
Before Turning the Burners On:
Fill the vessel with liquid shortening or oil up to the “oil level” marking. Cut solid shortening into small
pieces and pack tightly. Turn the burner “ON” for 10 seconds and turn off for about a minute. Repeat
this “ON-OFF”. Cycle until all the shortening is melted. If scorching occurs, lower the “ON” time. Do not
overfill the vessel.
LIGHTING INSTRUCTIONS:
1.
Set the thermostat and the gas cock dial on the combination gas valve to the “OFF” position.
2.
Wait for five minutes.
3.
Turn gas cock dial on the combination gas valve to “Pilot” position.
4.
Depress the gas cock dial and apply a lighted match or taper to the pilot.
5.
Hold the gas cock dial depressed for about 30 seconds or until pilot stays lit before releasing.
6.
If the pilot does not stay lit, repeat step 4 and 5.
Burners/Thermostat Operation:
1.
After the pilot is lit, turn the gas cock, dial “ON” position.
2.
Turn the thermostat dial to any temperature setting and observe the burners ignition. It should
ignite within four seconds.
Содержание DFFG-50
Страница 11: ...10 ILLUSTRATED PARTS Fryer Exploded View ...
