Mark EASYAIR 100, Техническое руководство

Страница: 8 / 58

8
1
3.2.2. VERTICAL ASSEMBLY WITH USING INSTALATION HANDLES.
I t is possible to assemble EASYAIR to a wall vertically on both sides of the gate (with the motor on the bottom or on the top).
For this option it is not important if you screw the handles down to the unit first and then screw the whole down to the wall or first attach the handles to the wall and then screw the curtain down
to the handles.
To perform vertical assembly, use M8x70 (outside the scope of Mark delivery) screws. Screw 2 or 3 brackets using the screws, passing through flat washers (3), to the threaded sleeves
mounted in the upper part of the housing.
IMPORTANT: In case of vertical assembly the minimal distance between the device and the floor (100mm) for access to the water coil blowdown connection and the cable terminal should be
provide.
IMPORTANT! T IMPORTANT! The device is intended for the operation in dry rooms, exclusively. Thus, pay particular attention to the condensation of water vapour on engine elements, since it
is not fitted for operating in humid environment.
IMPORTANT! The EASYAIR air curtains are not intended for the installation:
● Outdoors;
● In humid rooms;
● In rooms categorised as explosive environments;
● In rooms with very high levels of dustiness;
● In rooms with aggressive atmosphere (due to the presence of copper and aluminium structural elements in the heat exchanger and electric heaters).
IMPORTANT! The EASYAIR E air curtains are not intended for the installation on suspended ceilings.
3.3. ASSEMBLY AND INSTALLATION GUIDELINES
CONNECTING OF HEATING MEDIUM
Protect the heat exchanger terminal against the impact of the torque moment 1, when installing a pipeline transporting a heating medium. The weight of installed pipelines should not impose a
load on the heater’s terminals.
IMPORTANT! Pay particular attention to the leak-tightness of connections, when filing the hydraulic system. Make sure that the water flowing from a leaky connection does not leak to the
electric engine (at the vertical assembly)
IMPORTANT! It is recommended to use filters in the hydraulic system. It is recommended to clean/rinse the system, draining a few litres of water, prior to the connecting of hydraulic conduits
(the supply conduits, in particular).
VENTING OF DEVICE/DRAINING OF HEATING MEDIUM
To perform horizontal and vertical assembly, the exchanger on the right-hand side of the door vents automatically. In the case of lateral assembly with the stub pipes facing downwards, to vent
the exchanger, remove the side cover. Unscrew the screws (1) around the cover and remove the cover. A valve with a hose is situated below the cover.
SUPPL
Y
SUPPL
Y
RETURN
m
in
. 0
,1
m
RETURN
EXAMPLE OF HYDRAULIC SYSTEM
1. EASYAIR W100-200
2. VALVE WITHACTUATOR
3. VENTVALVE
4. SHUT-OFFVALVE
5. FILTER
6. CIRCULATINGPUMP
7. BOILER