Marconi LORAIN RHM800E50, Руководство пользователя

Страница: 18 / 74

I
I
I
I
I
I
I
I
I
I
I
HINGED END
0
REGULATOR AND ALARM CIRCUIT CARD A7 0
FACTORY ADJUST ONLY
LOAD SHARING ADJ
OVERVOLTAGE ADJ
ADJUSTMENT
HIGH VOLTAGE ALARM ADJ
(ON OTHER SIDE CIRCUIT CARD)
LOW ALARM ADJ
LOW VOLTAGE ALARM ADJ
0
0
CONTROL AND INDICATOR PANEL
(INTERIOR SURFACE)
0
Figure Regulator and Alarm Circuit Card Adjustment Potentiometer Locations
Repeat Steps and as to age. Unless otherwise specified. the equalize voltage
obtain the required float voltage.
has been factory adjusted to 54 VDC (24 cells at
cell). The potentiometer
changed, should be
done in small increments.
voltage
wilt be It is recommended that the
voltage
be checked necessary.
a) To obtain equalize output voltage, place the
FLOAT/EQUALIZE switch in the EQUALIZE
Allow DC output voltage to stabilize at its
new value.
5.3 Potentiometer ADJUST is accessible
through a hole on the panel of the rectifier.
potentiometer sets the value of the equalize output
To increase equalize voltage, adjust
EQUALIZE ADJUST clockwise. To
decrease, adjust potentiometer
11