MARCOLIN Ecotype, Руководство пользователя

Страница: 21 / 52

Operation of the buttons:
1. UNCOVERED
2. COVERED
3. Auxiliary control. If you have installed a Control Box model RHV 24 V, this
button may be used to activate the vibrator)
4. Free auxiliary control
ORDINANCE!
The remote control “TX MARCOLIN”
MUST BE KEPT AND USED EXCLUSIVELY by the operator.
After each use, the remote
control “TX MARCOLIN” must be stored in a not accessible place.
Before using the remo
te control “TX MARCOLIN”, the operator must verify the absence of any
unauthorised personnel close to the Control Box.
WARNING!
It is absolutely forbidden to use the covering system with the remote control “TX MARCOLIN” when the
vehicle is moving.
The constructor declines any responsibility.
3.2.5 Reprogramming the "TX MARCOLIN" radio remote control
Should it become necessary to
reprogram the “TX
MARCOLIN” radio remote control, please follow the
procedure below.
1. Enter programming mode by pressing 7 times the
Control Box LED button (no. 5 in the figure). After
having pressed the button 7 times, the Control Box will
beep intermittently and the LED button will flash.
2.
Now press any button of the “TX MARCOLIN” radio
remote control: The Control Box will beep again and the
LED button will turn off for one second, then it will turn
back on and remain lit. The “TX MARCOLIN” radio
remote control is now programmed.
3.
Check the correct operation of the “TX MARCOLIN”
radio remote control by testing the operation of the
motor in the two directions by opening and closing the
covering.
In case of errors or incorrect operation, contact Marcolin Covering Support Service or an authorized workshop.