Marco MIX PB3, Руководство по обслуживанию

Страница: 5 / 69

1000870,871,875,878,879,880,887 MIX Service Manual.b
Page 5 of 69
4. INSTALLATION
4.1 Mix Boiler Installation
Electrical Installation:
•
Electrical specification: 2.8kW-230VAC-50/60Hz
•
A moulded 13A IEC power cord is provided. This should be plugged into the IEC connection on the
rear of the boiler and plugged into a suitable 13A power outlet.
• When installing the machine, always observe the local regulations and standards.
Plumbing Installation:
• Mains water pressure required (limits): 5-50psi (35-345kPa) 0.5 – 5.0 bar
•
Fit a stop Valve on a cold water line and attach a 3/4" BSP male fitting, (e.g. 3/4" x 1/2" 311 or
washing machine type stop valve).
•
For US versions use 3/8” NPT male fitting.
•
Connect straight tailpiece of the hose to the stop valve fitting. Make sure that the pre-attached
sealing washer is fitted.
•
Turn on the water to flush any impurities, dust etc. from the inlet hose and water pipe. Allow
several litres through.
•
Connect right-angled tailpiece of the hose to the inlet valve of the boiler (3/4" BSP). Make sure the
sealing washer is fitted here also.
• Turn on water and check for leaks.