Blastmaster
®
Smart Box
15
INSTALLATION
Apply pipe thread
sealant to all pipe
threads to ensure an
airtight seal.
N-519
Always depressurize
the entire system,
disconnect all power
sources and lockout/
tagout all components
before any maintenance
or troubleshooting is
attempted. Failure to
comply with the above
warning could cause
electrical shock and
inadvertent activation of
equipment resulting in
death or serious injury.
W-562
Install Pressure Indicator - 6.5 cu. ft. and Smaller Abrasive Blasting Pots
Note: Additional components may be required to install Pressure Switch.
1) Remove and retain Ball Valve (3) from Moisture Separator (9).
2) Install Pipe Tee (1) on Moisture Separator (9).
3) Install Pipe Nipple (2) and Bushing (4) on Pipe Tee (1).
4) Install Hex Nipple (5) on Bushing (4).
5) Install Pipe Tee (7) on pipe nipple (5).
6) Install Pressure Transducer (6) on Pipe Tee (7).
7) Install Pressure Sensor (8) on Pipe Tee (7).
8) Install Ball Valve (3) on Pipe Nipple (2)
1
2
3
4
5
6
7
8
9
