Marco Polo ETP-LOC-01, Руководство по эксплуатации

Страница: 9 / 28

5
When attaching the tag to a collar, always select the side of the collar’s buckle
that is way from the D-ring for holding license and ID tags. The best
arrangement is to have the D-ring on the left, buckle in the center and the Marco
Polo tag on the right (turn the collar over if necessary to get this arrangement.) If
the collar is an adjustable type then the side away from the D-ring may have two
thicknesses of material, if this is the case then slip the tag’s collar clip over just
the outer thickness of the collar so that the clip rests between the two collar
straps.
The collar clip on the tag is designed to be used with collars ranging in size from
½” (12mm) wide and 3/32” (2mm) thick to 1” (25mm) wide and 3/16” (5mm)
thick. Collars in this size range are available to fit most pets. If you are choosing
a new collar for your pet then select the widest and thickest collar that will fit
them comfortably as this will provide the most secure attachment for the tag.
To remove the tag from the pet’s collar, pry the hooked end of the clip outwards
from the body of the tag with your finger and then slide the collar out of the clip.
Note: To avoid possible injury, the American Kennel Club (AKC)
recommends that ALL collars and tags of any kind be removed from pets
prior to crating.
Powering On the Locator and Tag
To power on the locato r: Press and hold the Power button (see the User
Controls and Displays section for the location of the power button) until all of the
display segments flash and the locator beeps twice.
Figure 4
Attaching the Tag to a Collar