Peak Limiter sub-menu – from this page it is possible to set the Output Channels Peak Limiter.
The following is an example screen for the Peak Limiter page where the Attack Time of the Peak
Limiter is set at 5ms, the Release Time is set at 0.2Sec and the Peak Limiter Active Threshold is
set at +15dB:
Once pushing ENTER the Peak Limiter's parameters can be modified using the “NAV/PM1”, “PM2”
and “PM3” encoders for editing the Peak Limiter's Attack Time [A]., Release Time [R] and Active
Threshold.
Once pushing ENTER the above screen will change as follows:
The Attack Time [A] can be edited using the “NAV/PM1” encoder, the Release Time [R] the “PM2”
encoder and the Peak Limiter Active Threshold the “PM3” encoder.
Delay page – from this page it is possible to set the Output Channels Delay Time from
000.0000mS up to
39
9.
0000
mS, by steps of 1mS or 20.8uS.
To set the Delay time press ENTER an arrow will appear on the left of the screen “->”. then use
the “PM2” encoder to set the Delay Time in steps of 1mS and the “PM3”, for setting the “fine”
Delay Time in steps of 20.8 microseconds.
The following is an example screen for the “Delay” page where the Delay Time of Output Channel 1
is set to 49.1872mS:
Polarity page – from this page it is possible to set the Output Channels Polarity, by using the
“PM2” or “PM3” encoders.
The polarity can be “Normal” or “Inverted” (which means rotated of 180 Degrees).
The following is an example of a “Polarity” screen where the Polarity of Output Channel 1 is set to
“Normal”
Out-1 Name Limiter
A: 5ms R: 0.2s +15.0dB
Out-1 Name Polarity
-> Polarity = Normal
Out-1 Name Limiter
->A: 5ms R:0.2s +15.0dB
Out-1 Name Delay
-> Delay = 49.1872mS
2 In - 4 Out Speaker Management System
