56
Montage- und Betriebsanleitung
Installation and Operating Instructions
EN
WARNING
Insufficient clamping up to the stop and failure to observe the minimum number of turns!
Insufficient clamping up to the stop and failure to observe the minimum number of rotations can cause the workpiece to
fly off like a projectile and cause serious injuries.
During clamping, screw in the clamping screw up to the stop, observing the specified minimum number of rotations
(see section 4.4 Technical data).
INFORMATION
The clamping screw is not captive!
Ensure that the clamping screw is clean.
Turn the clamping screw up to the stop using an hex-wrench with T-
2.
handle (see Fig. 11: Clamp the tool).
Set a torque wrench to a tightening torque of 7
Nm
.
3.
Tighten the clamping screw to the stop with the aid of the torque
4.
wrench.
RESULT
The tool is now fully clamped in the HTC clamping chuck and can be used.
Clamp the tool
Fig. 11:
