42
Montage- und Betriebsanleitung
Installation and Operating Instructions
EN
NOTICE
Use of shanks with recesses!
Use of shanks with Form B and E (DIN 1835) or shanks with HB and HE (DIN 6535) can result in radial run-out errors and
inaccurate balancing value of the whole system.
Use only shanks with Form A or fine balance the whole system.
NOTICE
Damage to the paint-sealed bleeder screw!
In the event of damage to the paint-sealed bleeder screw, the HTC clamping chuck is no longer functional and must be
taken out of operation immediately.
Do not damage or loosen the paint-sealed bleeder screw.
If the bleeder screw is damaged, the HTC clamping chuck must not be used for safety reasons.
In the event of damage, send the hydraulic chuck to MAPAL for inspection and repair.
NOTICE
Wear due to use of a power screwdriver for tightening the clamping screw!
Use of a power screwdriver for tightening the clamping screw will result in increased wear of the clamping set.
Tighten the clamping screw only manually.
