Mapal HPR400 plus, Инструкция по установке и эксплуатации

Страница: 16 / 20

16
Montage- und Betriebsanleitung
Installation and Operating Instructions
EN
N NOOTTIICCEE
W Weeaarr dduuee ttoo uussee ooff aa ppoow weerr ssccrreew wddrriivveerr ffoorr ttiigghhtteenniinngg tthhee ccllaam mppiinngg ssccrreew w!!
Use of a power screwdriver for tightening the clamping screw will result in in-
creased wear of the clamping set.
 Tighten the clamping screw only manually.
IIN NFFO ORRM MAATTIIO ON N
The indexable inserts may only be changed by trained personnel!
G Geenneerraall iinnffoorrm maattiioonn
44..11 IIlllluussttrraattiioonn ooff aa hhiigghh--ppeerrffoorrm maannccee rreeaam meerr H HPPRR440000 pplluuss
LLeeggeenndd
1 | Indexable insert
2 | Clamping screw
(TORX® PLUS)
3 | Wiper pocket
4 | Insert pocket
Individual components
44..22 TToooollss aanndd eeqquuiippm meenntt rreeqquuiirreedd
•
TORX® PLUS-Screw driver (tool diameter < 63 mm: 8 IP
and tool diameter
≥
63 mm: 15 IP)
•
TORX® PLUS-Torque wrench
•
High pressure pistol
Montage- und Betriebsanleitung
Installation and Operating Instructions
17
EN
EExxcchhaannggiinngg tthhee iinnddeexxaabbllee iinnsseerrttss
1. Clean the tool before beginning to
change the indexable inserts.
2. Release the clamping screw with the
suitable TORX® PLUS-Screw driver, to
do this rotate the screw anti-clockwise.
3. Remove the clamping screw.
Releasing the clamping screw
4. Carefully slide the insert up the insert
pocket and remove the indexable insert.
IIN NFFO ORRM MAATTIIO ON N
When exchanging an indexable
insert all indexable inserts must be
exchanged or rotated!
5. Remove the remaining indexable
inserts.
Removing the indexable insert
6. Clean the insert pockets using com-
pressed air.
7. Clean the insert pocket with cleaning
spirit, adhering to the manufacturer’s
instructions.
8. Clean the contact area of the insert
pocket using cleaning clay.
Cleaning the insert pocket
Montage- und Betriebsanleitung
Installation and Operating Instructions
16
EN