DEGASSING SYSTEM DG-50
INSTALLATION OPERATION & MAINTENANCE MANUAL
MA-DG-50r01
16
7.1
Temperature set point adjusting
There are only two parameters which is mandatory to adjust, before to start-up the system, these
parameter is temperature set point, and must be adjusted according to next procedure:
•
First of all, temperature units must be adjusted, by default, the controller is workshop programmed
for °C:
Press enter key and hold for at least 5 seconds. Then appears the next menu:
Then press index key and the next menu appears:
By pressing down arrow key is possible to change temperature units to °F:
To return to °C units, press up arrow key
Finally, to return to operation main display, press enter key.
•
Second stage, is site installation altitude in meters verification.
•
Once installation altitude is obtained, the corresponding values must be searched in the “Altitude”
field of the next table: