Manufacture Corporation 94-1518PF, Руководство пользователя

Страница: 147 / 280

138
10-2 MLD Snooping
Curiously enough, a network node that acts as a source of IPv6 multicast traffic is only an indirect
participant in MLD snooping—it just provides multicast traffic, and MLD doesn’t interact with it.
(Note, however, that in an application like desktop conferencing a network node may act as
both a source and an MLD host; but MLD interacts with that node only in its role as an MLD
host.)
A source node creates multicast traffic by sending packets to a multicast address. In IPv6,
addresses with the first eight bits set (that is, “FF” as the first two characters of the address) are
multicast addresses, and any node that listens to such an address will receive the traffic sent to
that address. Application software running on the source and destination systems cooperates
to determine what multicast address to use. (Note that this is a function of the application
software, not of MLD.)
When MLD snooping is enabled on a VLAN, the switch acts to minimize unnecessary multicast
traffic. If the switch receives multicast traffic destined for a given multicast address, it forwards
that traffic only to ports on the VLAN that have MLD hosts for that address. It drops that traffic
for ports on the VLAN that have no MLD hosts
Figure 10-2: The MLD snooping enable
10-2.1 Basic Configuration
The section will let you understand how to configure the MLD Snooping basic configuration
and the parameters.
Web Interface
To configure the MLD Snooping Configuration in the web interface:
1. Click Multicast, MLD Snooping and Basic Configuration.
2. Evoke to enable or disable the Global configuration parameters.
3. Evoke the port to join Router port and Fast Leave.
4. Scroll to select the Throtting mode with unlimited or 1 to 10
5. Click the save to save the setting
6. If you want to cancel the setting then you need to click the Reset button. It will revert to