23
Disabling a switch:
1. Press and hold down the setup button
for roughly 5 seconds.
The LED comes on (the card is in "radio peering" mode)
2. Press and release the setup button
The LED flashes slowly (card in "radio suppression" mode)
3. While the LED is flashing,
press "open" and "close" simultaneously
on the switch.
The LED flashes quickly then goes out: the button has been disabled.
Disabling a remote control:
1.
Press and hold down the setup button
for roughly 5 seconds.
The LED comes on (the card is in "radio peering" mode)
2.
Press and release the setup button
The LED flashes slowly (card in "radio suppression" mode)
3. While the LED is flashing,
press the "open" and "close" buttons simultaneously
for the
desired channel on the
remote control.
The LED flashes quickly then goes out: the remote control has been disabled.
Disabling all transmitters (switches, remote control...):
1. Press and hold down the setup button
for roughly 5 seconds.
The LED comes on
2. Press and hold down the setup button
for roughly 5 seconds.
The LED flashes quickly then goes out: all switches have been disabled, learning is
cleared too.
Other information
When the board is ready to receive a radio ID code (light on steady
– record – or flashing slowly –
disable), the LED will go out after 20 seconds of inactivity: the board has reverted to its normal
operating mode and you will need to start the procedure from the beginning again.
When the card is in "radio disable" mode, a short press on the setup button will turn off the LED,
and the card will revert to normal operating mode.
