!
WARNING:
DO NOT put hands into Lifting Mechanism while operating
the mount with the Remote Control.
After the Lift Housing is installed and power is connected,
press and hold the DOWN button on the Remote to lower
the Arm to horizontal. DO NOT lower past horizontal in
order to avoid hitting the mantel.
Hang the TV onto the TV Frame. Some older TVs are not weight
balanced. If the TV is much heavier on one side, slide the TV
slightly sideways to balance and level the TV.
Attach with 4 Screws {18}.
Install the TV Frame {26} using 4 Screws {20} and
Washers {11}. These screws can also be used to fine
tune level the TV. Always remember to tighten.
THIS STEP REQUIRES TWO PEOPLE
Install the Lift Housing {30}
PAGE 10
MantelMount MM8
{11}
{20}
{18}
DOWN Button:
Lowers the Mount
RECESSED:
Trace the Cardboard Template vertically onto
the wall about the centerline at the correct height from
Step 9. Use a level to ensure the cutout is plumb.
NON-RECESSED:
Use the Cardboard Template to mark
the location of the Housing. MantelMount is located in the
same spot for all installations.
C
L
Crush Hazard
C A U T I O N
Stay clear of area
between wall and
TV during operation
Distance from
mantel to opening
from Step 9
12
13
14
15
