Manitowoc S model, Инструкция по установке, использованию и уходу

Страница: 68 / 72

Maintenance Section 4
4-14
Part Number 000002477 3/08
Removal from Service/Winterization
GENERAL
Special precautions must be taken if the ice machine is
to be removed from service for an extended period of
time or exposed to ambient temperatures of 32°F (0°C)
or below.
Follow the procedure below.
1. Clean and sanitize the ice machine.
2. Move the ICE/OFF/CLEAN switch to OFF.
3. Disconnect the electric power at the circuit breaker
or the electric service switch.
4. Turn off the water supply.
5. Remove the water from the water trough.
6. Disconnect and drain the incoming ice-making water
line at the rear of the ice machine.
7. Energize the ice machine and wait one minute for
the water inlet valve to open.
8. Blow compressed air in both the incoming water and
the drain openings in the rear of the ice machine
until no more water comes out of the inlet water lines
or the drain.
9. Make sure water is not trapped in any of the water
lines, drain lines, distribution tubes, etc.
10. Fill spray bottle with sanitizer and spray all interior
food zone surfaces. Do not rinse and allow to air dry.
11. “Frontseat” (shut off) the receiver service valves.
Hang a tag on the switch as a reminder to open the
valves before restarting.
CVD1486 WATER COOLED CONDENSING UNIT
1. Perform steps 1-11 in previous column.
2. Disconnect the incoming water and drain lines from
the water-cooled condenser.
3. Insert a large screwdriver between the bottom spring
coils of the water regulating valve. Pry upward to
open the valve.
Pry Open the Water Regulating Valve
4. Hold the valve open and blow compressed air
through the condenser until no water remains.
!
Caution
If water is allowed to remain in the ice machine in
freezing temperatures, severe damage to some
components could result. Damage of this nature is
not covered by the warranty.
SV1624