Manitowoc NBT60XL, Руководство оператора

Страница: 48 / 184

2-34
Published 11-01-2020 Control # 710-00
SAFETY PRECAUTIONS NBT60XL OPERATOR MANUAL
Use tag lines (as appropriate) for positioning and restraining
loads. Check the load slings before lifting.
Make sure that everyone is clear of the equipment and work
area before making any lifts.
Never swing over personnel, regardless of whether load is
suspended from or attached to the boom.
Hand Signals
A single qualified signal person shall be used at all times
when:
• Working in the vicinity of power lines.
• The equipment operator cannot clearly see the load at
all times.
• Moving the equipment in an area or direction in which
the operator cannot clearly see the path of travel.
At all times use standardized hand signals (Figure 2-6) - that
have been previously agreed upon and completely
understood by the operator and signal person.
If communication with the signal person is lost, equipment
movement must be stopped until communications are
restored.
Keep your attention focused on the equipment’s operation. If
for some reason you must look in another direction, stop all
equipment movement first.
Obey a signal to stop from anyone.
JIB
To avoid death or serious injury, follow the procedures in this
manual during erection, stowage, and use of the jib.
Install and secure all pins properly.
Control movement of the jib at all times.
Do not remove right side boom nose pins unless the jib is
properly pinned and secured on front and rear stowage
brackets.
Do not remove the pins from the front stowage bracket
unless the jib is pinned to the right side of the boom nose.
Properly inspect, maintain, and adjust jib and mounting.
When assembling and disassembling jib sections, use
blocking to adequately support each section and to provide
proper alignment.
Stay outside of jib sections and lattice work.
Watch for falling or flying pins when they are being removed.
Example decal. For reference only. 9023-48
Fo
r
Reference
Only