Manitowoc K00440, Инструкция по установке, эксплуатации и обслуживанию

Страница: 24 / 28

24 Part Number 000008463 Rev 02 3/16
Maintenance Section 3
Cleanup Steps for Hard Surfaces
1. Carefully scoop up glass fragments and powder using
stiff paper or cardboard and place debris and paper/
cardboard in a glass jar with a metal lid. If a glass jar is
not available, use a sealable plastic bag.
NOTE: Since a plastic bag will not prevent the mercury
vapor from escaping, remove the plastic bag(s) from the
home after cleanup.
2. Use sticky tape, such as duct tape, to pick up any
remaining small glass fragments and powder. Place the
used tape in the glass jar or plastic bag.
3. Wipe the area clean with damp paper towels or
disposable wet wipes. Place the towels in the glass jar
or plastic bag.
NOTE: Vacuuming of hard surfaces during cleanup is
not recommended unless broken glass remains after all
other cleanup steps have been taken. It is possible that
vacuuming could spread mercury containing powder or
mercury vapor, although available information on this
problem is limited.
If vacuuming is needed to ensure removal of all broken
glass, keep the following tips in mind:
• Keep a window or door to the outdoors open.
• Vacuum the area where the bulb was broken using
the vacuum hose, if available; and remove the vacuum
bag (or empty and wipe the canister) and seal the bag/
vacuum debris, and any materials used to clean the
vacuum, in a plastic bag.
• Promptly place all bulb debris and cleanup materials,
including vacuum cleaner bags, outdoors in a trash
container or protected area until materials can be
disposed of properly.
• Check with your local or state government about
disposal requirements in your area. Some states and
communities require fluorescent bulbs (broken or
unbroken) be taken to a local recycling center.
• Wash your hands with soap and water after disposing
of the jars or plastic bags containing bulb debris and
cleanup materials.
• Continue to air out the room where the bulb was
broken and leave the H&AC system shut off, as practical,
for several hours.
Cleanup Steps for Carpeting or Rugs
1. Carefully scoop up glass fragments and powder using
stiff paper or cardboard and place debris and paper/
cardboard in a glass jar with a metal lid. If a glass jar is
not available, use a sealable plastic bag.
NOTE: Since a plastic bag will not prevent the mercury
vapor from escaping, remove the plastic bag(s) from the
home after cleanup.
2. Use sticky tape, such as duct tape, to pick up any
remaining small glass fragments and powder. Place the
used tape in the glass jar or plastic bag.
NOTE: Vacuuming of hard surfaces during cleanup is
not recommended unless broken glass remains after all
other cleanup steps have been taken. It is possible that
vacuuming could spread mercury containing powder or
mercury vapor, although available information on this
problem is limited.
If vacuuming is needed to ensure removal of all broken
glass, keep the following tips in mind:
• Keep a window or door to the outdoors open.
• Vacuum the area where the bulb was broken using
the vacuum hose, if available; and remove the vacuum
bag (or empty and wipe the canister) and seal the bag/
vacuum debris, and any materials used to clean the
vacuum, in a plastic bag.
• Promptly place all bulb debris and cleanup materials,
including vacuum cleaner bags, outdoors in a trash
container or protected area until materials can be
disposed of properly.
• Check with your local or state government about
disposal requirements in your area. Some states and
communities require fluorescent bulbs (broken or
unbroken) be taken to a local recycling center.
• Wash your hands with soap and water after disposing
of the jars or plastic bags containing bulb debris and
cleanup materials.
• Continue to air out the room where the bulb was
broken and leave the H&AC system shut off, as practical,
for several hours.