Manitou MT-X 625 2-E3 Series, Руководство оператора

Страница: 58 / 132

2-26
A - VISUAL ALARMS
• A1 - A2 - A3: There is a significant reserve of longitudinal stability.
• A4 - A5: The lift truck is approaching the limit of longitudinal stability, move with care.
• A6: The lift truck is close to the limit for longitudinal stability. Drive carefully.
• A7: The lift truck is very close to the limit of longitudinal stability. Manoeuvre with extreme
caution.
• A8: The lift truck is at the authorised limit of longitudinal stability.
B - HYDRAULIC MOVEMENT CUT-OFF
"HANDLING" MODE
• A8: All “AGGRAVATING” hydraulic movements are cut-off. Only perform de-aggravating
hydraulic movements in the following order: retract and raise the boom.
"BUCKET" MODE
• A8: The boom lowering and extension movements are cut-off, the other movements remain
available.
"SUSPENDED LOAD" MODE
• A8: All “AGGRAVATING” and boom raising hydraulic movements are cut-off. Only the boom retraction hydraulic movement is
available.
C - DISABLING “AGGRAVATING” HYDRAULIC MOVEMENT CUT-OFF
Remain very vigilant during this operation. The only information available to the operator is the lift truck’s
dynamic stability.
In certain cases, in order to get out of a difficult situation, the operator can bypass this safety
system. Button C temporarily disables the cut-off of “AGGRAVATING” hydraulic movements.
- Hold down button C, indicator lamps A9 and C1 lamp will light (60 second time delay),
and at the same time perform the necessary “AGGRAVATING” hydraulic movement with
extreme care.
D - TESTING THE LONGITUDINAL STABILITY LIMITER AND WARNING DEVICE
- Short press the button to verify at any time that the longitudinal stability alarm is working.
• Correct operation: All the LEDs A1 to A8 light for two seconds and an audible signal is sounded.
NOTE: This test does not check the proper adjustment of the longitudinal stability limiter, which must be inspected daily or after every
10 hours of service (see: 3 - MAINTENANCE: A - DAILY OR EVERY 10 HOURS OF OPERATION).
E - FAULT INDICATOR LAMP
A permanently lit fault indicator lamp E, together with a combination of illuminated LEDs, indicates a
major fault liable to affect the safety of the lift truck. Refer to your agent or dealer.
- The fault indicator lamp plus LEDs A1 and A7 lighting alternately with A4 and A8 indicates a
defective link in the operation of the longitudinal stability limiter and warning device.
- The fault indicator lamp plus continuously lit LEDs A7 and A8 indicate a faulty box.
F - STRAIN GAUGE
Disassembly or calibration of the strain gauge is prohibited, this must only be done by specially trained
personnel, consult your dealer.
A8
A7
A6
A5
A4
A3
A2
A1
C
C1
A8
A7
A4
A1
E
F
647421
(22/08/2017)
MT-X
625
Série
2-E3
+
COMFORT