Manitou MT 1058 R PRIVILEGE, Руководство пользователя

Страница: 109 / 139

3-32
F - EVERY 2000 HOURS OF SERVICE
Carry out the operations described previously as well as the following operations.
F1 - COOLING LIQUID
DRAIN
These operations are to be carried out if necessar y or ever y two years at the beginning of
winter. Place the lift truck on level ground with the I.C. engine stopped and cold.
DRAINING THE LIQUID
- Open the I.C. engine bonnet.
- Remove the shroud 1 (fig. F1/1).
- Set a container under drain valve 2 (fig. F1/2) on the radiator and drain plug 3 (fig. F1/3)
of the engine block and loosen them.
- Remove filler por t 4 (fig. F1/4) from the radiator and open the heating control at the
maximum level in order to ensure proper emptying.
- Let the cooling circuit drain entirely while ensuring that the por ts do not get clogged.
- Check the condition of the hoses as well as the fastening devices and change the hoses
if necessar y.
- Rinse the circuit with clean water and use a cleaning agent if necessar y.
FILLING THE LIQUID
- Tighten the drain valve 2 (fig. F1/2) and drain plug 3 (fig. F1/3) (tightening torque 40 N.m).
- Slowly fill up the circuit with cooling liquid (see: 3 - MAINTENANCE: LUBRICANTS AND
FUEL) to the middle of gauge 5 (fig. F1/4) through filler por t 6 (fig. F1/4).
- Put back filling plug 4 (fig. F1/4).
- Run the I.C. engine at idle for a few minutes.
- Check for any possible leaks.
- Put back the shroud 1 (fig. F1/1)
- Check the level and refill if necessar y.
The I.C. engine does not contain any corrosion resistor and must be filled during the whole year with a
mixture containing 25 % of ethylene glycol-based antifreeze.
F1/1
1
F1/4
5
6 4
F1/2
2
F1/3
3