Manitou 120 AETJ L, Руководство по ремонту

Страница: 134 / 142

4
80-8-86-M.84
D - A
DJUSTING THE LOW ARM SENSOR
UP TO PLATFORM No. 505421:
- Set the platform in transport position (Telescope retracted, arms
lowered) and leave it switched on.
- Remove the protective cover 5 (Fig. D1) (2 bolts, No. 10 spanner)
situated under the left-hand side of the intermediate joint 6 (Fig. D2).
- Loosen the lock nuts 7 (Fig. D1) (No. 24 spanner)
- Tighten or loosen the sensor 8 (Fig. D1) until the LED next to the
power supply cable switches from red to green.
- Re-tighten the lock nuts.
- Refit the protective cover.
FROM PLATFORM No. 505422
- Locate the sensor 9 (Fig. D2) between the two sides of the interme-
diate joint.
- Same procedure as for adjusting platforms UP TO PLATFORM No.
505421 except for removing and refitting the protective cover.
E - A
DJUSTING THE RETRACTED TELESCOPE SENSOR
- Locate the sensor 10 (Fig. E1) located at the front between the two
counterweights.
- The follow the same procedure as for ADJUSTING THE LOW ARM
SENSOR .
F - A
DJUSTING THE OVERLOAD SENSOR
- Raise the basket 50cm above the floor in a horizontal position.
- Remove the protective cover 11 (Fig. F1) (2 bolts, No. 10 spanner).
- Place 250kg in the basket.
- Loosen bolt 12 (Fig. F2) (No. 14 spanner) until the overload sensor
13 (Fig. F2) triggers: the platform's alarm sounds.
D1
D2
E1
8
5
7
6
9
10
F1
11