Manitou 120 AETJ L, Руководство по ремонту

Страница: 118 / 142

8
80-8-11-M.84
E - U
SING THE CALIBRATOR
D1
SEVCON
CAN CALIBRATOR
Controller A
Menu
Value - +
Controller B
1
D2
2
1 Traction
OK
2 Pump
OK
Mise sous tension
1.1 Traction
Personalities
1.2 Traction
Status
1.3 Traction
Test
1.4 Traction
BDI
1.5 Traction
Fault Log
1.6 Traction
Setup
1.7 Traction
Motor Setup
1.8 traction
Display
1.1.1A Trac Pers
I. Max
1.1.1F Trac Pers
I. Max
1.1.2 Trac Pers
Accel
1.1.3 Trac Pers
Decel
1.1.4 Trac Pers
Creep Speed
1.1.5 Trac Pers
Flat Regen
1.1.6 Trac Pers
...
2.1 Pump
Personalities
2.2 Pump
Status
2.3 Pump
Upper Box Pers
2.4 Pump
Upper Box Test
2.5 Pump
Lower Box Pers
2.6 Pump
Lower Box Test
Switch on
DESCRIPTION
- The calibrator (Fig. D1) (Ref. 622813) is used to adjust and configu-
re the variable speed drive. It is also used as a diagnostic tool,
displaying the variable speed drive's various voltage, current and
temperature values and the status of all its inputs.
INSTALLATION
- Please refer to the section on REMOVING THE VARIABLE SPEED
DRIVE to access the electronic module.
- Locate the loom cable connected to 2 (Fig. D2) on the electronic
module; then take the calibrator's plug 1 (Fig. D1) and, depending
on the circumstances:
- Connect it to the spare socket on the loom.
- If the loom does not have a spare socket, slip the adaptor
cable (Ref. 677519) between the loom and the module's
connector and then connect it to the spare socket on this
cable.
CALIBRATOR MENU
- See the illustration below.