Manitou Systems AS960, Руководство оператора

Страница: 10 / 28

4. Initial Setup
4.1 Hydraulics
^
WARNING
Pressurized fluids can penetrate the skin.
Disconnect and lock out power source
before disconnecting and/or connecting
hydraulic hoses.
The mulcher is equipped with short hoses that are
connected to the hydraulic motor. You must connect
your skidsteer hoses to these hoses.
Hydraulic couplers are not provided with the mulcher.
You must install couplers and connect your skidsteer
pressure, return and case drain hoses to the mulcher
hoses. Install your couplers to the hoses listed in the
table below.
Fitting Size Hose Description Qty.
3/4 JIC FM Pressure & Return 2
3/8 JIC FM Case Drain 1
Identify the pressure port hose and connect your hoses
to the brush mulcher hoses.
4.2 Motor Pressure Port
C930 - A port on block (B port on motor)
C940 - A port on block (B port on motor)
C950 - A port on block (B port on motor)
C970 - A port on block (B port on motor)
4.3 Maximum Allowable Case Pressure
C930 - 100 psi, case drain required.
C940 - 100 psi, case drain required.
C950 - 100 psi, case drain required.
C970 - 100 psi, case drain required.
4.4 Optional Two Speed Motor Setup
The optional two speed motor requires fine tuning to
the flow provided by the carrier machine.
The fine tuning will need to be performed in the field
while operating in conditions where normal work will
be performed.
Manitou Group recommends this be done by the
Dealer or Territory Sales Rep.
^
WARNING
Moving parts can crush and cut.
Entanglement hazard.
Keep clear of moving components.
1.
An RPM meter is required. Open cover and
place reflective tape (A) on bearing end of shaft.
Measuring shaft speed on the bearing end will
provide the most accurate results. RPM setting
from factory is 1525 RPM with 36 GPM.
A
2.
Loosen nut (B).
3.
For high speed setting (1st speed), 1900 RPM is
recommended. To adjust high speed, turn nut (C).
4.
For low speed high torque setting (2nd speed),
1750 RPM is recommended. To adjust low speed,
loosen nut (D) and turn nut (E).
8
Attachments.Manitou-Group.com