13
The signal check screen shows the strength and quality of the
freesat signal received from your satellite dish. If the signal
strength or quality is below 50%, you should check the satellite
dish connection at the back of the receiver (switch the receiver
off and reconnect the cable if necessary). If the connection is OK,
consult your dealer or installer.
When the signal strength and signal quality shown are 50% or
more, you can continue to tune in the receiver. Press
to proceed.
Enter your postcode using the number buttons on the remote
control. You do not need to enter a space. Once you have entered
your postcode, press the
button and then press
to proceed.
HINT:
You should set the SCART output to RGB if your
television is compatible with this output (see your television’s
manual). If in doubt, set the output to Composite.
HINT:
Enter your postcode with the number buttons by
pressing the correct button on the remote a number of
times to produce the relevant letter (printed above each
button), or number, in the same way as ‘texting’ with a
mobile phone. For example, for an ‘S’, you would press the
7
button four times. If you make a mistake, the button
deletes the last character entered.
