Mandalay 2006 Presidio, Руководство пользователя

Страница: 72 / 130

WARNING: Make sure before exiting the motorhome, that the step is activated
and/or extended. Due to the height of the motorhome, you may accidentally
slip or fall if attempting to exit without use of the step. If the step will not
operate, use extra care when exiting. Never activate the step when someone is
using it, and be sure to keep hands, feet, children, and pets away from the
mechanism when activated.
When the power step is activated, it extends and retracts automatically when the door is
opened or closed. There are two ways to control the operation of the step:
Switch Panel — Power to the step, provided by the chassis batteries, may be turned on and
off with the rocker switch located just inside the door. When on, the step will extend whenever
the door is opened, and retract when the door is closed. The step may be kept in the
extended position by turning the switch off after the step is lowered. To maintain the battery
life this switch should be turned off while in storage.
Ignition Switch — Whenever the ignition switch is in the ON position, the power step is
automatically activated. This will prevent accidentally driving with the step extended, since it
will retract with the door closed.
The motorhome is equipped with numerous exterior
storage compartments. The storage compartment doors
are equipped with gas struts which assist with opening
and holding the doors in the open position, if these struts
become weak, contact your dealer for proper
replacement. If the wrong size strut is used it could cause
damage to the door.
On compartment doors located under the slideout rooms
there are adjustable gas struts, these will allow the door
to open at two different angles. One position can be used
to open the door at 90º from the closed position (when
slideout is extended), and the other setting is to open the
door greater than 90º from the doors closed position.
To adjust the gas struts, loosen the strut anchor nut,
located on the strut bracket, and position the strut in the
desired bracket inlet. Tighten the strut anchor nut. Repeat
procedure for the other gas strut as well. Do not close the
compartment door until both gas struts are secure and in
the same inlet setting.
5-2
EXTERIOR OPERATIONS
2005 PRESIDIO
POWER ENTRY STEP
STORAGE COMPARTMENTS