Malmet Bedpan / Urinal Bottle Washer Disinfector (ES-D)
Detergent Model with Hands Free Operation
Operation, Maintenance and Installation Manual
Issue 5
Page
12
June 23
2.2
Service Connections
MODEL
COLD WATER
SOIL LINE
ELECTRICAL
ES915
GB¾ Male
100mm ‘S’ or ‘P’ Trap
240V 1 phase @ 20 Amps
50 hertz
ES935
GB¾ Male
100mm ‘S’ or ‘P’ Trap
240V 1 phase @ 10 Amps
50 hertz
2.3
Plumbing Connections
These installation guidelines must be followed to ensure the device will operate as intended.
Installations must be carried out by a qualified, licensed tradesperson.
Water Supply
–
Note: Water Supply connections must comply with AS/NZS3500.1 and be Watermark Certified.
This device requires only a potable cold-water connection; the water entry point is on the lower rear right-hand
side of the device when viewed from the front. Please refer to the Service connection layout diagram for exact
location.
The device can be connected to any potable mains pressure cold water supply as a back-flow prevention air gap
is incorporated in the design of the water tank. Complies to AS 2845.2
Cold Water
–
Note: See device specifications table for water quality requirements
Pressure:
100-400kPa
Temperature:
15-25°C
Nominal Flow:
10L/Min
Connection:
GB ¾” BSP
•
The water supply is to be connected to an isolating valve or cistern stopcock placed approximately 1200mm from the
floor to the right-hand side of the device (preferably not behind the device).
•
If inlet water flow pressure is higher than 400 KPa an inline pressure reducing valve should be fitted.
Note:
Old hose sets should not be re-used; it is recommended new compliant hose sets are used on installation.
Waste/Soil Line Connection
Note: Bell Ends can be cut off to suit
Diagram C2
For reasonable connection working space allow 150-200mm from rear of device to wall.
The device is 600mm wide and the centre of the trap is 300mm from each side.
