OPERATING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fi re or explosion may result
causing property damage, personal injury or loss of life.
A. Follow these instructions exactly. This appliance has a pilot which must be lighted by hand.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the
fl oor because some gas is heavier than air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electric switch; do not use any phone in your building.
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's
instructions. If you cannot reach your gas supplier, call the fi re department.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will
not push in or turn by hand, don't try to repair it, call a qualifi ed service technician. Force or
attempted repair may result in a fi re or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualifi ed service
technician to inspect the appliance and to replace any part of the control system and any gas
control which has been under water.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information above on this label.
2. Push in the control knob slightly and turn clockwise to "OFF".
NOTE: Knob cannot be turned from "PILOT" to "OFF" unless knob is pushed in slightly. Do not
force.
3. Wait fi ve (5) minutes to clear out any gas. If you smell gas, STOP! Follow "B" in the safety
information above on this label. If you do not smell gas, go to the next step.
4. Turn knob on gas control counterclockwise
to "PILOT."
5. Push in control knob all the way and hold in. Immediately light the pilot by pushing in the red
lighter button. Continue to push the red lighter button until the pilot is lit. Continue to hold
the knob in for about one (1) minute after the pilot is lit. Release the knob and it will pop back
up. If the knob does not pop up, turn off the gas shut off valve and call a service technician.
Pilot should remain lit. If it goes out, repeat steps 3 through 6.
6. Turn gas control knob counterclockwise
to "ON."
To Turn Gas Off
1. Push in gas control knob slightly and turn clockwise
to "OFF." Do not force.
FD2/FD3 Page - 9
Pilot Assembly
CONTROL VALVE
el.
THERMOPILE
THERMOSTAT
THERMOPILE
THERMOSTAT
PILOT GAS TUBE
PILOT ADJ. SCREW
MANIFOLD PRESSURE TAP
INLET PRESSURE TAP
ON/OFF GAS
CONTROL KNOB
GF2/3 5/1/15
