Malibu Boats Wakesetter 247 LSV, Руководство пользователя

Страница: 151 / 170

Storage and Winter Lay-up
Due to the problems that can occur from improper winterization, we recommend that you
take your boat to a certified Malibu dealership to perform this task. Without proper
preparation, storage for long periods of time may cause parts of the engine and
transmission to rust due to lack of lubrication. Also, if your boat will be stored in freezing
conditions, water inside these components to include cooling system, heater and shower
could result in major damage to your boat. Damage done due to improper winter storage
will void your warranty. Here is our list of suggestions to keep your boat in top condition.
Prior to boat being removed from water:
• Fill fuel and add 1 ounce of STA-BIL ® fuel stabilizer for each 5 quarts of
gasoline.
• Operate boat for at least 15 minutes in water or using a flush system to allow
treated fuel to flush engine.
• Add lightweight engine oil (SAE-10 or fogging oil) slowly to the engine while
engine is slightly above idle. Turn engine off. Consult your local dealer for
correct procedure.
To be completed when boat is put on trailer or resting cradle:
• Remove bilge T-handle and transom drain plug immediately after removing
from the water.
• Clean and dry the boat interior and exterior thoroughly. Inspect boat hull for
residue and remove if present.
• Clean bilge area thoroughly and operate the bilge pump to remove any water
from bilge lines.
• Remove all seat cushions and open all storage areas. Store the seat cushions in a
cool dry place.
• Apply coat of wax to entire surface of boat.
• Flush engine-cooling system with clean water. Do not exceed 1500 RPM while
flushing for 5-10 minutes.
• Perform annual scheduled maintenance. Refer to engine owner’s manual for
complete engine winterization procedures as well as scheduled maintenance.
Note: Damage done due to improper engine winter storage will void your warranty. It
is highly suggested that you allow a trained Malibu technician to perform this service.
• After performing engine winterization, remove engine safety switch and spin
engine over a few seconds to remove excess water found in pump bodies.
• Remove the negative cable from battery. Charge battery to fuel charge and
remove from boat.
• Clean all traces of dirt, oil and grease from engine, transmission and bilge. Coat
all areas on transmission and engine where paint has been removed with touchup
paint.
• Use duct tape to seal the exhaust flaps closed to prevent dirt and rodents from
entering exhaust.
• Remove propeller assembly, and store in safe place.
• If your boat is equipped with an optional heater or hot-water shower, remove
both hoses and blow through hose to remove excess water.
• Cover the boat with cover, tarp or, if available, shrink-wrap tarp. Also, due to the
excess weight that can occur from rain and snow for boats that are stored
outside, it is suggested that you make a support of 2 inch PVC piping that can be
mounted under the covering material. The rounded PVC piping will ensure the
cover does not tear and will eliminate pooling water inside boat.
4-15
Chapter 4_11_ Chapter 4 doc.qxd 11/19/10 12:33 PM Page 15