Malco FasGroov FGVK, Руководство пользователя

Страница: 7 / 17

FGV
1-3/4”
FGLV
2-5/8”
1”
1-1/2”
VEE TOOL
FASGROOV-VEE TOOL
Push the FasGroov-Vee Tool through a test piece of
ductboard.
Measure the amount of fiberglass remaining between
the foil backing and the deepest part of the vee-groove
cut. There should be 1/8” of fiberglass remaining (see
illustration for width of cut.)
If adjustment is needed: (1) Turn the blade adjustment
knob counterclockwise to lower the blade for a deeper
cut or (2) Turn the blade adjustment knob clockwise to
raise the blade for a shallower cut.
Repeat adjustment until the proper depth of cut is
achieved.
FASGROOV #5 TOOL
Push the FasGroov #5 Tool through a test piece of
ductboard.
The blade should cut deep enough to skin all of
the fiberglass off the foil backing. By using more
pressure on the FasGroov #5 Tool, any remaining
fiberglass may be cleaned off the foil.
If adjustment is needed: (1) Turn the blade adjust-
ment knob counterclockwise to lower the blade for
a deeper cut or (2) Turn the blade adjustment knob
clockwise to raise the blade for a shallower cut.
Repeat adjustment until the proper depth of cut is
achieved.
Note:
It is important to use this tool according to the
direction arrows on the label.
#5 TOOL
Use FGK Knife
to cut staple flap.
VEE VEE VEE #5
#5
12 13